|
Post by chrissyt on Dec 9, 2020 8:27:03 GMT -5
I have tried to find the fuse for the automatic wire for the aft bilge pump. I disconnected all the fuse holders on the batteries but the pump will still run. Does anyone have any ideas where I should check next?It is a 2019 270 cc. Thanks, Rob
|
|
|
Post by outtadblue on Dec 9, 2020 9:51:59 GMT -5
It does not have a fuse. The wire should go to a circuit breaker inside the console labeled aft bilge pump. At least that’s how mine is.
|
|
|
Post by chrissyt on Dec 9, 2020 11:17:12 GMT -5
This is the wire for the float. Usually they are wired direct to the battery. I will check the breaker to see if it always hot.Thank you, Rob
|
|
|
Post by popeye on Jan 1, 2021 16:29:20 GMT -5
The float (usually) won't have a fuse. The float is just a switch and has no load. The fuse / breaker will be on the pump circuit.
|
|
|
Post by jski59 on Jan 3, 2021 8:53:56 GMT -5
Are you trying to keep it from automatically turning on? Not sure if that's a good idea.
I've had a couple Rule pumps that would randomly turn on and off if the sensors got dirty...once they were cleaned, no more problems.
|
|