|
Post by juergen2 on May 28, 2020 3:15:55 GMT -5
Hi, I have a factory installed switch panel (more like tactile switches) which has several of the LED's and actual switches failing. So I called Seminole and they gave me the part number for it's replacement and also gave me the manufacturers telephone number (Ultimate Marine Panel in Miami). I ordered a new rocker switch panel from them and also asked for a connector pin-out description. According to Ultimate Marine they wire the panel according to a sample provided by Seminole (hard to believe). So I called Seminole for a connector pin-out of the boat side wire harness and was told it's not available (the switch panel is connected to the boat's electrical devices via a large connector). So my question is: Does anyone have a connector pin-out description of either the boat wire harness or the switch panel? Thanks for help Juergen Mader
|
|
|
Post by outtadblue on May 28, 2020 8:29:09 GMT -5
Look under the Owners Resource page. There is a wiring diagram that you can down load. It has all the wires with colors that go to the plug and switch panel. A couple of the wires are going to the wrong switch in the new panel. I can’t remember which one’s but you will have to swap them. Also, I think the diode is reversed on the nav/anchor light switch. I cut my plug off and hard wired all my wires.
|
|
|
Post by Sailfish 2360 wac on May 30, 2022 18:52:22 GMT -5
I’m thinking about replacing my membrane switch on my 2360 wac. Did you end up switching yours out? Any recommendations?
|
|
|
Post by fishnfool on May 30, 2022 20:50:33 GMT -5
A lot of owners including Finatic have swapped their membrane switch panel for the new toggle switch panel. Perhaps Glen will chime in.
|
|
|
Post by Maysport on May 31, 2022 10:05:35 GMT -5
I replaced the switch panel in my 2007 218CC using a panel I designed and had New Wire Marine manufacture. They were good to work with. From the before pictures below you can see that the switches weren't in great condition, were working intermittently. They were hard to read at night as the lettering had worn off the backplate and the switches weren't backlit.
In working with NWM, I was able to go from 9 switches + 12V plug to 9 switches + 12V plug + dual USB charger port in the same width. There was no room to increase the width between the Yamaha ignition switch panel and the console bump-out. I increased the height slightly to add a backlit Sailfish logo. Below is the design template they sent for final proofing. The Sailfish logo backlight is wired to come on whenever the ignition is on. All switches are backlit if the running light switch is turned on. You can see the installed look below at night. I hope this helps and good luck!
|
|
|
Post by kevford75 on Oct 22, 2022 6:01:50 GMT -5
How expensive was that, is it easier to get the switch covers?
|
|
|
Post by schlnrnd on Oct 23, 2022 11:50:57 GMT -5
I replaced mine with new switches from New Wire Marine. About $15-$20 per switch. Etched and backlit.
|
|
|
Post by popeye on Oct 27, 2022 15:00:06 GMT -5
|
|