|
Post by gpm414 on Jun 10, 2020 23:05:54 GMT -5
Quick question about the switch panel in my new to me 2012 2680 WAC. The accessory switch is a three way rocker with an upper light on, middle off, lower light on positions. Can someone explain what accessories are on when the upper half is depressed and the round light it on? And what accessories are on when the lower half is depressed and the narrow light is on. The middle position is off. I opened the panel and tried to follow the wires, but that's pretty much impossible. I'm all ears Sailfish experts, can someone explain how this switch works. The photos may appear that both lights are on but only one is on at a time. It's just the reflection of the light inside the switch . The switch is labeled ACCY I am assuming this came from the factory with this switch, but maybe not? Thanks, Gary
|
|
|
Post by abouttime2fish on Jun 11, 2020 6:50:30 GMT -5
My accessory switch turns on the tube light overhead one way, nothing the other.
|
|
|
Post by hookedup on Jun 11, 2020 7:44:46 GMT -5
Just changed out my ACC switch covers with the actual names of what it controls and changed out the horn cover for a red horn switch cover. They're sure cheap enough and makes it easy for anyone else at the console. I used rockerswitchpros.com/and I was happy with the switch covers, but there are plenty of others. Just a suggestion or what to do once you find out what the switch controls
|
|
|
Post by outtadblue on Jun 11, 2020 9:20:16 GMT -5
There is no telling what it controls if anything. They are used to and accessories as needed. Some dealers add things and owners add to them. I have two accy switches on my boat. One has nothing going to it. The other, I added underwater lights.
|
|
|
Post by gpm414 on Jun 14, 2020 9:04:17 GMT -5
There is no telling what it controls if anything. They are used to and accessories as needed. Some dealers add things and owners add to them. I have two accy switches on my boat. One has nothing going to it. The other, I added underwater lights. Thanks, that make total sense. I've slowly gone through the wiring and replaced anything that looked suspicious or corroded. Replaced the bus bars behind the dash and connectors that weren't heat shrink ends. Also removed several "wires to no where" that were from previous owners that were cut or spiced. My moto has always been don't cut corners and do it right the first time.
|
|
|
Post by outtadblue on Jun 15, 2020 11:41:08 GMT -5
Sounds like you are on the right path. Clean that mess up.
|
|