|
Post by popeye on May 21, 2022 9:06:59 GMT -5
So the grab bar that was mounted on my 2660 live well fell off. I was suprised that it was only heald in place by screws. The holes in the fiberglass have stripped out. I can't get behind it to bolt it with washers and nuts....
Any ideas?
Thinking I might have to fill the holes with some epoxy, sand, and redrill.
|
|
|
Post by finatic on May 21, 2022 9:26:56 GMT -5
I would use this on the holes. Maybe reapply and also use 5200 on the back side of the grab bar
|
|
|
Post by fishnfool on May 21, 2022 13:53:42 GMT -5
Any pics?
How about toggle bolts?
|
|
|
Post by noslackline on May 21, 2022 15:13:03 GMT -5
|
|
|
Post by popeye on May 22, 2022 9:07:00 GMT -5
The toggle bolts seem like a great idea. Not sure there is much room for them. I'm figuring less than a 1/2" between the outside and the livewell.
|
|
|
Post by popeye on May 22, 2022 9:07:38 GMT -5
The marine-tex is probably the way to go, but i'm already sitting on some epoxy.
|
|